China World Technology Medical Equipment Service Group
|Model Number:||989803174881 / 453564243501|
|Minimum Order Quantity:||1pcs|
|Delivery Time:||3-5 working days|
|Payment Terms:||T/T(wire transfer), Western Union, Paypal|
|Product Name:||REF 989803174881 PN 453564243501 Philip VS1 VS2+ Patient Monitor Rechargeable Liithium Ion Battery||Brand:||Philip|
|Ref:||989803174881||Part No .:||453564243501|
|Type:||Lithium Ion||Volt:||10.8–11.1 V|
|Capacity:||2150–2300 MAhr||Operating Time:||>4.5 Hours, With Continuous SpO2 And NBP Interval Measured Every 15 Minutes|
989803174881 Patient Monitor Accessories,
453564243501 Patient Monitor Accessories,
Rechargeable Liithium Ion Battery
REF 989803174881 PN 453564243501 Philipilip VS1 VS2+ Patient Monitor Rechargeable Liithium Ion Battery
The rechargeable lithium-ion battery used in the display is a smart battery with built-in circuitry that sends battery status information to the display. Battery power lasts at least 4.5 hours (VS2+) without printing (VS2+ only), with NBP measurements taken every 15 minutes. Follow these guidelines:
Replace the battery if the following condition occur:
|Operating Time||>4.5 hours, with continuous SpO2 and NBP interval measured every 15 minutes|
Battery Information and Alarms The condition of the battery is reported through messages, technical alarms and error codes.
When the monitor is in standby mode, the information required for battery service will appear if:
The information area of the Technical Alarm Monitor displays the following battery technical alarms:
Warning: Dispose of used batteries in an environmentally responsible manner. Do not put batteries in ordinary waste containers. Check with your hospital administrator for local arrangements.
NOTE Before removing the battery, perform a hard shutdown.
4.Disconnect the battery cable from the connector and remove the battery from the monitor.
1. Connect the battery cable. Make sure the cable is securely attached to the connector.
2. Insert the battery into the compartment with the cable closest to the case.
3. Replace the battery cover and TorxT10 screws.
4.Confirm that the battery is installed correctly by observing if the charging LED lights up
Contact Person: Andy