PN 115-002504-00 Patient Monitor Parts Anesthesia AG Module AION 03-31

Mindray ARTEMA patient monitor anesthesia AG module AION 03-31 PN 115-002504-00

► Brief Introduction

The AG module can measure gases that have various properties of absorbing the infrared. To measure the concentration of a gas, send it to the sampling room, select the infrared of a specific wavelength with an optical infrared filter, and transmit it through the gas. For a given volume of gas, the higher its concentration is, the more the infrared that will be absorbed by the gas is, and the less the infrared that will be transmitted through the gas is. The concentration of the measured gas is in inverse proportion to the volume of the infrared that is transmitted through the gas.Therefore, the AG concentration can be obtained by calculating the infrared. For the AG module that implements the measurements of multiple gases, multiple infrared filters are necessary.

The AION™ 03 is a sidestream muligas analyzer aimed at the high-end market segment. It is easy to integrate and offers the user a vast array of options to fulfill any market need.

The anesthesia gas (AG) monitoring can be used for measuring the anesthesia gas and respiration gas of the patient in the anesthetic status. AG module provides the end-tidal numerics and inhaling numerics of the gases mentioned below.

• Carbon dioxide (CO2): The measured numeric is EtCO2 (Max. exhaling value: Max. exhaling numeric detected during the respiration).
• Nitrous oxide (N2O): Laughing gas.
• Oxygen (O2): Optional function.
• Anesthetic (AA): Refers to the monitored anesthetic (DES, ISO, ENF, SEV or HAL).
• Airway respiration rate (AwRR): respiration per minute (BrPM).

► Key features:

• NDIR side stream gas analyzer
• Measures CO₂, N₂O, Halothane, Isoflurane, Enflurane, Sevoflurane and Desflurane in any mixture
• Automatic identification of two anesthetic agents
• Interfaces to paramagnetic or fuel cell oxygen sensors
• Calculates inspired and expired concentrations of all gases
• Generates up to five simultaneous waveforms
• Fast warm up (ISO specification within 45 seconds, full accuracy within 10 minutes)
• Flow controlled gas sampling pump, 70-200 ml/min user selectable gas sampling flow
• RS232 host interface
• Small size 80 x 107 x 51.5 mm (3.1" x 4.2" x 2")
• Low power consumption (typically less than 3.7 W)
• Market leading reliability, proven MTBF greater than 40.000 h.
• Connects directly to Artema DRYLINE™ water traps and Artema OXIMA™ Galvanic Oxygen Sensor, Servomex Paramagnetic Oxygen Sensor or SPIRIT™ Respiratory Mechanics System.
• Fully compatible with other AION™ versions.

► Built-in AG

► AG parameters

• The AG module is not intended to monitor multiple halogenated anaesthetic gases.
• To avoid explosion hazard, do not use flammable anesthetic agent such as ether and cyclopropane for this equipment.

Please kindly contact us, if you are interested in Mindray ARTEMA patient monitor anesthesia AG module AION 03-31 PN 115-002504-00, Thank you!