REF 2037082-001 Li-Ion Battery 7.2V 4500mAh 33Wh For GE MAC800 ECG Machine

GE MAC800 ECG Machine Battery REF 2037082-001 7.2V 4500mAh 33Wh

Battery Maintenance

It uses a rechargeable battery containing lithium-ion cells. The battery contains a built-in electronic fuel level indicator and protection circuit. Due to the bias current required to operate embedded electronic devices, batteries may be discharged even if they are not installed in the device. Its discharge rate depends on the ambient temperature at which it is stored. The higher the temperature, the faster the discharge. To extend the charging time of the battery when not in use, store it in a cool, dry place. A new, fully charged battery should last approximately 2 hours under normal operation. Indicators on the screen show the status and capacity of the battery. (For more information about the battery indicator. When the indicator is blinking orange, connect the MAC system to AC power to fully charge the battery. As the battery ages, the total charging capacity of the battery decreases and is permanently lost. Results, Storage and Availability If the capacity is no longer sufficient to daily operation, you need to replace the battery.

Battery safety

When handling batteries, pay attention to the following warnings.

WARNING: Explosion or fire. Use of non-recommended batteries may result in injury or burns to the patient or user and may void the warranty. Use only batteries recommended or manufactured by GE Healthcare.

WARNING: INJURY: Batteries may leak under extreme conditions. The liquid is corrosive to eyes and skin. If liquid gets into your eyes, skin or clothing, rinse with clean water and consult a doctor.

WARNING: ENVIRONMENTAL HAZARD. Do not dispose of battery by burning or burning. Follow local environmental regulations for disposal and recycling.

GE MAC800 ECG Machine Battery REF 2037082-001 7.2V 4500mAh 33Wh

Specification

Inserting the Battery

This system is equipped with a lithium-ion battery that recharges when connected to a system connected to AC power.

1. Carefully turn the device over and find the empty battery compartment.

2. Insert the battery as shown below.

NOTE: The battery will charge when installed on a system connected to AC power. You can use the system connected to an AC power supply. Do not operate the system on battery power until the battery is fully charged. This is indicated by a battery charge indicator on the screen and a glowing yellow LED next to the screen.

Replacing the Battery

When the battery’s full-charge capacity can no longer operate the for an adequate length of time, use the following instructions to replace the battery:

Thank you so much for your attention .If you're interested in  GE MAC800 ECG Machine Battery REF 2037082-001 7.2V 4500mAh 33Wh,feel free to contact us .Thank you .