Edan SE-2003 SE-2012 ECG Cable 10 Leads 16 Hole PN 01.57.471225

 Edan SE-2003 SE-2012 ECG cable 10 leads 16 hole p n 01.57.471225

►Brief Introduction

This ECG Cable is work for Edan SE-2012 Holter System Recorder (including analysis software and recorder). It is intended to record, analyze, display, edit and generate report of ambulatory ECG. It is mainly used for (but not limited to) the following indications:

1. Evaluation of symptoms suggesting arrhythmia or myocardial ischemia.
2. Evaluation of patients for ST segment changes.
3. Evaluation of drug response in patients taking anti-arrhythmic medications.
4. Evaluation of patients with pacemakers.

The Holter system is intended to be used in hospitals and clinics by trained personnel under the direction of doctors. The analysis results are offered to doctors on an advisory basis only. The Holter system is intended for adult, paediatric patients and infants weighing less than 10 kg.

► Long Time Sampling

Edan Holter Recorder is designed with low power consumption, which enables it to support as long as 8 days recording with a single piece of Li-ion battery.

► Electrode Placement
10-electrode standard lead wires are utilized by the recorder (12-channel) to create a 12-lead ECG signal. Different placement positions of 10 electrodes will form different lead modes, and it is recommended to place electrodes as below:

► Preparing the Skin

Thorough skin preparation is very important. The skin is a poor conductor of electricity and frequently creates artifacts that distort the ECG signals. By performing methodical skin preparation, you can greatly reduce the possibility of noise caused by muscle tremor and baseline drift, ensuring high-quality ECG waves. There is natural resistance on the skin surface due to dry, dead epidermal cells, oils and dirt.

To Prepare the Skin

1. Shave hair from electrode sites, if necessary. Excessive hair prevents a good connection.
2. Wash the area thoroughly with soap and water.
3. Dry the skin with a gauze pad to increase capillary blood flow to the tissues and to remove the dead, dry skin cells and oils.

NOTE: If you don’t have enough time for the steps above, you can use pledget to scrub the electrode sites to remove the dead, dry skin cells and oils and increase capillary blood flow to the tissues.

If you want to explore more details about Edan SE-2003 SE-2012 ECG cable 10 leads 16 hole PN 01.57.471225, please let us know. Looking forward to receiving your early inquiry.