Drager 8608442 1.7m Flow Sensor Cable - New Original Replacement Parts for Ventilator Signal Wire

Drager 8608442 1.7m Flow Sensor Cable - New Original Replacement Parts for Ventilator Signal Wire

 
 
► Brief Introduction
 

This is a brand new, original flow sensor cable that connects the ventilator unit and the flow sensor, establishing a communication link between them. It is a key transmission accessory for real-time measurement of tidal volume and airway flow in ventilators.

This cable has part number 8608442 and is 1.7 meters long, making it suitable for a wider range of applications.

The cable has a gray exterior and an outer sheath made of oil-resistant and bend-resistant medical-grade PVC. Multiple shielded signal wires inside reduce external electromagnetic interference.

 
 
► Features

1. Establish a signal channel

Connecting the mainboard and airway flow sensor, continuously transmitting flow acquisition signals. The ventilator relies on these signals to calculate tidal volume, airway velocity, and pressure parameters.

2. Shield against external electromagnetic interference

Neonatal ventilators require extremely high accuracy in flow data. Shielded cables can avoid interference from surrounding electrical equipment, preventing flow value drift and jumps, ensuring accurate measurements.

3. Moisture-proof interface

A sealing ring on the plug prevents moisture and disinfectant mist from entering the contacts, avoiding oxidation and corrosion of metal pins, reducing intermittent signal loss, and minimizing circuit failures.

4. Power supply to the sensor

Not only transmitting monitoring signals, but also providing stable power to the external flow sensor of the main unit, ensuring continuous sensor operation.

► Parameters
 

 
 
► Product Picture
 

►FAQ
 

Q1: Are there any environmental requirements for long-term storage of brand new cables after unpacking?

A1: Store at room temperature away from light. Do not subject the cable to heavy pressure to avoid permanent deformation of the sheath. Keep the original packaging bag for dust protection as much as possible.

Q2: After replacing only the cable, is it necessary to calibrate the ventilator's flow module?

A2: It is recommended to perform a flow calibration procedure after installation to ensure that the accuracy of flow and tidal volume measurements meets neonatal clinical standards.

Q3: After installation, the flow reading deviation is large, even though the connectors are tightened. What else should be checked?

A3: Confirm that the plug seal is not missing. Also, check that the cable is not run parallel or close to high-power power cords to avoid electromagnetic interference.

90 Day Warranty                             SGS ceryification