PHiliph MRX M3535A Defibrillator Printer 600-25000-01 M3535-63075

The PHiliph MRx M3535A Defibrillator Printer   is the integrated thermal array printer built into the PHiliph MRx defibrillator.This isn't a standalone device. It's an internal component that sits inside the MRx chassis, working as the device's built in documentation system. When a clinician prints a strip, the printer produces a hard copy record of exactly what happened during a resuscitation  the ECG waveforms, the shocks delivered, the patient's vital signs, and the timing of each intervention. That paper trail becomes part of the patient's medical record, supports post-event review, and feeds into quality improvement programmes.

Printing

The  MRx outputs data through its built in 50 mm or 75 mm internal printer instead of hospital network connected printing devices. You set up alarm logs directly on this defibrillator unit for transmission to the Information Center central recorder if available. After finishing configuration on  MRx users can manage these alarm records via the Record Store page within All Controls at the Information Center. Vital signs trending reports produced by the MRx are only printable locally on the equipment.

The following can be printed

・Event Summary (short, medium, and long)
・Vital Sign Trends
・12-Lead
・Operational Check
・Configuration
・Status Log

・Device Information

Speed:  25 or 50 mm/s with an accuracy of +5%
Amplitude Accuracy:  +5% or + 40 uV, whichever is greater
Paper Size:
• 50 mm (W) x 30 m (100 ft.) (L)
• 75 mm (W) x 30 m (100 ft.) (L)

When removing the printer

1. Open the printer door and remove any paper that's inside. For the 75 mm printer, lift the white plastic cover and remove the paper roll.

2. Locate the two Phillips screws at the back of the printer and loosen them. Be careful not to damage any wires in the process.

3. Grip the printer by its internal frame and pull it straight out of the printer slot.