Mindray D3 Defibrillator Parameter Module 050-000324-80850 051-000230-00 M51A-20-80850 051-000231-00

Mindray D3 Defibrillator Parameter Module 050-000324-80850 051-000230-00 M51A-20-80850 051-000231-00

 
 
► Brief Introduction
 

This circuit board is the original parameter module for the Mindray D3 defibrillator, responsible for parameter acquisition and data analysis and conversion by the defibrillator monitor. The part numbers for this parameter module are 050-000324-80850, 051-000230-00, and M51A-20-80850 051-000231-00. The parameter module features a green circuit board design with a transparent soft shell for protection and includes a snap-fit slot for direct insertion into the defibrillator, fitting snugly into the device's internal space.

 
 
► Features

1. ECG Signal Acquisition

Multi-channel signal amplification and noise reduction circuitry filters electromagnetic interference, clearly identifying dangerous arrhythmias such as ventricular fibrillation and ventricular tachycardia, ensuring accurate AED automatic interpretation.

2. Resistance to Defibrillation Impact

The circuit board incorporates an independent isolation transformer and protection circuit, preventing damage to the acquisition board when releasing high-voltage defibrillation power, thus avoiding module burnout and system shutdown.

3. Integrated Plug-in Module

The modular assembly eliminates the need for individual component disassembly. In case of failure, the entire unit can be replaced, completing repairs in just over ten minutes and minimizing downtime for emergency equipment.

4. Anti-Detection Function

Real-time monitoring of electrode contact impedance. If electrodes become detached or have poor contact, the device immediately displays an alarm, preventing accidental discharge and loss of monitoring waveforms.

► Parameters
 

 
 
► Product Picture
 


 

►FAQ
 

Q1: The device blacks out and restarts during a discharge. What could be causing this?

A1: Most likely, the internal high-voltage circuit of the module has failed, causing a high-voltage surge to the entire power supply. Replacing the entire acquisition module will completely resolve the issue.

Q2: The module's transparent casing clip is broken. Can I replace only the PCB board and keep the old casing?

A2: Not recommended. The casing provides insulation, limiting, and high-voltage isolation protection. Missing clips can cause module displacement, leading to a short circuit between the high-voltage end and the main unit, posing a safety hazard. Replacing the entire assembly is recommended.

Q3: After the module gets wet and exposed to disinfectant moisture, can it be used again after simple drying?

A3: Moisture can corrode the precision acquisition chip and isolation transformer on the board. It may appear normal in the short term, but it is very easy for signal drift and instability to occur during use. It is recommended to replace them directly to avoid failure in emergency situations.

90 Day Warranty                             SGS ceryification