Original Parts MS1R-10416-V1.2 EDAN CADENCE II Fetal Monitor Interface Board

Original Parts MS1R-10416-V1.2 EDAN CADENCE II Fetal Monitor Interface Board

 
 
► Brief Introduction
 

This is the original interface board for the EDAN CADENCE II Fetal Monitor. The part number is MS1R-10416-V1.2.

This interface board connects to various modules within the device, working collaboratively with them. It transmits commands from the mainboard to each module and also transmits data from the modules back to the mainboard, acting as a relay station between the mainboard and the internal modules.

 
 
► Features

1. Signal Relay

It acts like the device's "traffic control center," distributing commands from the mainboard to various modules such as printers, buttons, and sensors, while simultaneously feeding data back from each module to the mainboard, ensuring synchronized and normal operation of functions such as tire monitoring, printing, and alarms.

2. Multi-Interface Adaptation

All interface definitions and signal protocols on the board are specifically customized for CADENCE II, fully compatible with the device's printer module, button board, and sensors. No additional debugging is required after replacement; all modules can communicate normally.

3. Anti-interference

The components on the board can filter interference in the power supply and signals, avoiding problems such as printing abnormalities, button malfunctions, and data loss caused by unstable voltage or signal interference, ensuring stable transmission of monitoring data.

4. Original Factory Compatibility

As an original factory control board of the same specifications, it can directly replace the old board after installation, restoring all relevant functions of the device, including printing, buttons, and expansion interfaces, without modifying device settings, reducing downtime for maintenance.

► Parameters
 

 
 
► Product Picture
 

► FAQ

Q1: The device is experiencing simultaneous printing failure and button unresponsiveness. Is the interface board faulty?

A1: In cases where multiple modules fail simultaneously, the interface board is most likely faulty. First, check if the connectors of each module are loose. If the connectors are normal, the signal distribution circuit of the interface board is faulty and needs to be replaced.

Q2: The device repeatedly reports "module communication error," and the error persists even after replacing a single module. What is the problem?

A2: If a single module is working normally but still reports an error, the fault lies in the "intermediate hub," which is the interface board. It is responsible for communication between the modules and the main board. An abnormality in the interface circuit will cause all modules to report communication errors.

Q3: Does replacing the interface board require device calibration?

A3: No, the interface board is only responsible for signal transmission and command distribution. It does not affect the tire monitoring calibration data of the device. The device can be restored to normal operation directly after replacement.

90 Day Warranty                             SGS ceryification