01.13112575011 Mainboard With Paper Sensor Board Wiring For Edan F200 Fetal Patient Monitor

01.13 Mainboard With Paper Sensor Board Wiring For Edan F200 Fetal Patient Monitor

Wiring instruction

This connector wiring is an original signal transmission accessory for the Edan F200 fetal monitor, specifically designed to connect the device's motherboard and paper sensor board. It uses medical-grade multi-core shielded cable with foolproof connectors at both ends, precisely matching the interface specifications of the motherboard and paper sensor board. It is a crucial link ensuring stable transmission of the paper detection signal. When the device experiences problems such as "no paper alarm" or "paper detection failure," replacing this connector cable can quickly fix the issue without additional adjustments, directly restoring the paper detection function. It is a commonly used accessory when repairing the F200 monitor.

Check Printing

1. Press the PRINT key to start printing.

2. Check if the recorder starts printing. Enable the Print Self-Test function.

3. Restart the monitor and verify if the recorder is printing abaseline.
4. Go into DEMO mode and print some traces and see if all the traces are clear on paper.

Main Functions

1.Precise Signal Transmission: Responsible for stably transmitting the paper status signals (such as "paper present/no paper" or "paper roll in place") detected by the paper sensor board to the main board, ensuring accurate identification of the paper status by the device.

2.Power Supply Support: Some models also provide low-voltage power to the paper sensor board, ensuring normal sensor operation and preventing detection failure due to unstable power supply.

3.Made of bend-resistant and aging-resistant wire, it can withstand frequent disassembly and equipment vibration, and is not prone to problems such as wire breakage and poor contact.

Interface connection diagram