Biocare ECG-1210 Battery HYLB-952 14.8V 2200mAh BAT1602001 For ECG Machine Power Supply
Battery Introduction:
This battery features a neat, elongated package with a smooth, protective blue ABS plastic casing. One end of the power interface has red and black insulated wires, and the other end has a white plastic plug that perfectly matches the device's interface, ensuring a secure connection. It houses a built-in 14.8V, 2200mAh lithium-ion battery with a dedicated interface fully compatible with the device, making it the core power supply component ensuring the stable operation of the ECG-1201 electrocardiograph.
Power Supply:
Power suppy
|
AC/DC |
AC power supply
|
100V-240V,50Hz/60Hz,70VA |
Battery power supply
|
Rechargeable lithium battery, 14.8V,2200mAh |
Battery capacity
|
Supparts about 3.0 hours for continuous operation |
| Battery chargetime |
Approximately 4 hours for total discharge
|
Key Advantages and Features:
1. Supports Full Device Operation: The 2200mAh capacity supports over 3 hours of ECG testing. During power supply, it supports full operation of the ECG machine, including waveform acquisition, data storage, printing, and transmission, meeting the mobile examination needs of outpatient and emergency settings.
2. Multiple Safety Protections: Built-in overcharge, over-discharge, overcurrent, and short-circuit protection circuits effectively handle voltage fluctuations and load changes in clinical scenarios, enhancing safety.
3. High Durability: Utilizes high-quality lithium-ion cells with a cycle life of over 300 charge-discharge cycles, withstanding high-frequency clinical use and reducing replacement frequency.
4. Intelligent Charge and Discharge Management: Automatically starts charging and automatically disconnects power upon full charge. Real-time battery level display allows medical staff to plan usage in advance.
Battery Operation Notes:
The device is equipped with a built-in, fully sealed, maintenance-free rechargeable lithium battery, along with a comprehensive automatic charge-discharge monitoring system. When the device is connected to an AC power source, the battery will charge automatically. With the device powered on, the battery status is displayed on the right edge of the LCD screen . After a complete discharge, the battery takes approximately 4 hours to fully recharge.
When fully charged, the battery supports continuous printing for 90 minutes and standby operation for over 10 hours. When the device runs on battery power, a battery indicator appears on the front-panel LCD screen, showing the remaining battery capacity in 5 different modes. If the battery capacity drops too low to support normal operation, the device will shut down automatically to prevent permanent damage to the battery.
Recharge the battery in a timely manner after it is fully discharged. If the device will not be used for an extended period, recharge the battery every 3 months—this practice helps extend the battery’s service life.
Attention:
• Never use a wire to directly connect the battery’s “+” and “-” terminals—this could pose a fire hazard.
• Do not place the battery near open flames, as this may lead to an explosion risk.
• Do not disassemble the sealed battery under any circumstances.
• If the battery fails to recharge, or if it operates for less than 10 minutes after a full charge, replace the battery promptly.
• Do not disassemble, puncture or squeeze the battery casing. Do not throw the battery into fire or near heat sources to prevent battery leakage, fire or explosion.
Your message must be between 20-3,000 characters!
