PHiliph M3015A Double Link Bar Upper Left Server-To-Monitor Connect Interface for M3

PHiliph M3015A Double Link Bar Upper Left Server-To-Monitor Connect Interface for M3

• Product Description

The phrase "PHiliph M3015A double link bar upper left" refers to the double-link interface (dual-link interface) on the PHiliph M3015A Measurement Server Extension module used for connection and communication, and its physical location on the top left side of the device.

• Functions:

   

• Communication Bridge:

It allows the M3015A to transmit digitized physiological data with the M3000A/M3001A and M3046A.

• Serial Connection:

It's called "dual" because it's typically used to vertically stack three devices.

• Lower Interface:

Connects to the top of the M3015A expansion module.

• Upper Interface:

Connects to the bottom of the M3000A/M3001A measurement server.

• Note: If only a monitor and expansion module are present, it connects both directly.

• Product Specifications

• User Guide

• 1. Power Off:
  Always disconnect the monitor from the power source before servicing.

•  

   

  2. Access:
  Open the rear or top cover of the M3015A module to expose the connection point.

•  

   

  3. Replacement:
  Remove the old/defective link bar. Align the new Double Link Bar with the connector on the M3015A circuit board.

•  

   

  4. Secure:
  Ensure the connector is fully seated and locked into the "Upper Left" position as indicated by the housing guides.

•  

   

  5. Test:
  Reassemble the unit and perform a checkout procedure to verify data transmission from connected modules.

• Notes

1. Handle with Care:
The plastic clips are strong but can snap if excessive force is applied.

2. ESD Safety:
Use an anti-static wrist strap when handling internal connectors to prevent electrostatic discharge damage.