Mindray Datascope Passport 2 Monitor Parameter Panel Component PC-P-86-94V-0 18-03-008 0670-00-0682-02

Mindray Datascope Passport 2 Monitor Parameter Panel Component PC-P-86-94V-0 18-03-008 0670-00-0682-02

1. Product Overview

This is a core parameter panel component designed specifically for the Mindray Datascope Passport 2 patient monitor, model numbers PC-P-86-94V-0 and 0670-00-0682-02. Serving as a "connector" between the monitor and physiological signal sensors, this module integrates external interfaces such as ECG and SpO₂, along with corresponding circuitry, to adapt to the Passport 2's signal transmission logic. Its included white and gray dedicated flat ribbon cables further ensure reliable acquisition of vital sign data. In short, it is one of the crucial hardware components ensuring the monitor can properly acquire key physiological data.

2.Main Functions

Its primary function is to connect the monitor to external sensors: on one hand, it receives patient vital sign data from ECG and pulse oximetry sensors via the ECG multi-pin interface and SpO2 data interface on the panel; on the other hand, using its built-in flat ribbon cable and circuit board, it stably transmits this data to the monitor's main unit processing unit, allowing the main unit to analyze and display this physiological information. Simultaneously, it serves as the hardware carrier for device parameter interaction, ensuring signal connectivity between external components and the main unit.

•T1 Connector

A standard three wire phone jack used to mate with either the YSI series 400 or 700 temperature probes. The monitor automatically detects which probe is connected.

•SpO2 Connector

A 14-lead Mini-D ribbon type female connector used to attach the SpO2 sensor to the monitor.

•ECG Connector

This connector is used to attach ECG cables.

3. Installation and Removal Methods

Removal: First, disconnect the monitor's power supply. Open the corresponding area of ​​the outer casing. Gently pull off the two ribbon cables by pinching their connectors (do not pull the cables directly). Then, loosen the clips or small screws securing the component to remove it.

Installation: Align the component with the mounting position inside the main unit and secure it firmly. Tighten the screws or clips. Then, connect the two ribbon cables to the corresponding connectors on the component (make sure the connectors are not reversed). Finally, reinstall the casing and test if the interface functions correctly.

4. Precautions for Use

(1) The monitor's power supply must be disconnected before disassembly or installation to avoid short circuits that could damage the component or the main unit. When plugging or unplugging the ribbon cables, only pinch the connectors; do not pull the cable body to prevent internal circuit breakage.

(2) Although the component is made of flame-retardant material, avoid liquids and high-temperature environments to prevent the circuit board from getting damp or deformed.

(3) After installation, be sure to test the signal transmission of the ECG and SpO2 interfaces to ensure that sensor data can be transmitted to the main unit normally.

(4) This is a Passport 2 specific component; do not use it with other monitor models to avoid interface incompatibility and damage.

(5) When cleaning, use a soft, dry cloth or a soft cloth dampened with a small amount of medical disinfectant to wipe the surface. Do not allow liquids to seep into the panel crevices or inside the buttons